8-12-26:  Had a customer install this on a GEN 2 and it was so tight it broke, getting measurements of the GEN 2 DAA bowl and will have a separate option to correct this.

Reloader's rejoice... The Hopper Topper is born.  Fits your standard 6" bowl Mr. Bullet Feeder GEN 1 (see pictures).  This top was designed from scratch and keeps your bullets in the bowl if you over fill your Mr. Bullet Feeder.  Often times I would just throw another couple hundred bullets in without checking how many are in there.. resulting in a mess on the work bench.  We also added a pocket to the design for keeping your bullet nose guide shims close to the work area.  Do you know where your spare shims are?  If you use a small pocket screw driver for clearing jams, it will fit there as well.

Install notes.. Not all hoppers are made the same.  You may need to slightly squeeze the bowl to start the Hopper Topper onto the bowl.  Using a hammer is not recommend.  You do not need to drive the top 100% into the groove.  The fit is very tight.