CZ Scales 2.0 UL

RERELEASED 2023, PA12 Ultralight

CZ Scales 2.0 have been on demand for their captivating looks.  Sorry for the delay, was proving out the material with this ultralight design.  These are made in house out of the same durable material of our 1911 Bite/AR/AK grips.

-  They weigh 0.46 ounces without screws

-  Torx Screws Included

 -  Material is Black through out, but are paintable if you so desire.

-  Overall width is based on the very widely used STI 2011 competition grip, width at base 1.330

-  Even sided upper scoop cuts to aid in mag release access, width at the scoop 1.110

**Fits all 75 and 85 full sized frames.  Confirmed fit on CZ 75, 75B, SP01, Shadow 1, Shadow 2, and SP01 Accu shadow.  Other models are compatable, but not confirmed by us. 

Install notes:  Scale grips are produced for a very tight fit.  Clean your frame of any carbon or thread locker build up.  Primarily check that the angled face that locates the front of the grip is clean.  When installing the screw, press the grip forward to ensure screw clearance to the frame. Insert your screws and check that it will thread in.  Do not proceed if the screw isn't a perfect 90 degree angle.  Only when the screw goes in perfectly straight should you proceed with the screw installation.  Please do not cross thread your frame or over tighten the screws.  FYI.... due to manufacturing processes, frames may have the fastener locations in different spots left vs right.  If you are not comfortable slotting the Scale grip screw hole to alow the screw to go in perfectly straight, seek the assistance of a qualified gunsmith.  Check that your screws are tight after and during your next match.  Blue thread locker on your grip screw is recommended. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.